Wright Tool 4966 1/2" 12 Point Deep Impact Socket (1/2" Drive)

  • Media
$10.92 each


Tool-to-fastener contact area is ten times greater than with a conventional design, and almost twice that of a First Generation AS954 tool.

Part Number: 970433492
Mfg Part Number: 4966

  • The Wright Drive was created and patented by the Wright Tool Company, taking full advantage of advanced CAD/CAM technologies. It actually improves the torque load capabilities of every fastener, whether it’s a soft stove bolt or a hardened aerospace fastener
  • Torque loads are moved away from fastener corners to prevent rounding
  • Stress is distributed over a much larger area of the fastener
  • Leverage is improved, eliminating fastener rounding and increasing tool strength
  • Tool-to-fastener contact area is ten times greater than with a conventional design, and almost twice that of a First Generation AS954 tool
  • Maximum .057" length of flat contact at engagement under load with 5/8" Wright Drive design and SAE Grade 5 fastener
  • Users and bystanders must wear safety goggles
  • To avoid possible eye injury from flying objects, safety goggles or equivalent protection conforming to ANSI Z87.1 shall be worn and kept clean by the user and all persons in the immediate area where any tool is being used
  • Do not hold impact sockets, universal joints or extensions while an impact tool is running. Serious hand injury can occur
  • 3/4” drive and larger drive size impact sockets require the use of a ret ring or a Pin & O-ring to secure the socket to the driving square
  • Never use a nail or homemade pin for holding a socket in place
  • Never exceed the manufacturer’s gun pressure rating
  • Impact sockets are to be used to turn (tighten or loosen) fasteners while being driven by a power, impact or hydraulic driver
  • Never dwell on a socket after it has stopped running. This can damage both the socket and the fastener
  • Place the socket all the way on the fastener before starting the gun
  • Adaptor strength is limited to the smallest drive square member
  • Mind the joints between the gun and fasteners for less loss of torque and less wear
  • Use the correct size socket, do not use metric sockets on inch fasteners or inch sockets on metric fasteners, because the fit is not good enough. Do not use hex sockets on square fasteners or square sockets on hex fasteners
  • Never use sockets as a driver for hex or square bits or shafts
  • Large drive impact sockets are inherently heavy and care needs to be taken during handling
  • Socket opening configurations shall be inspected before each use and their use discontinued at the first sign of significant wrenching surface deterioration
  • Inspect and discard worn or cracked sockets
  • Nom. Size - 1/2"
  • Drive Size - 1/2"
  • Length - 3-1/4"
  • Ds - 13/16"
  • Dd - 15/16"
  • Bd - 17/64"
We use cookies on our site to provide you with the best user experience. This data may be used for personalization, analytics, and ads. Disabling cookies may also prevent parts of website from working properly.